Views: 316 Author: Site Editor Publish Time: 2021-11-16 Origin: Site
The steel rule auto die bending machine turns the metal blank into a tool with a specific shape and size under the action of an external force. The steel rule auto die bending machine working through external force greatly improves the production efficiency and effectively realizes the high efficiency of modern production.
What are the common troubleshooting methods for steel rule auto die bending machines?
For the operator, what are the precautions for using the steel rule auto die bending machine?
What is the advantage of a steel rule auto die bending machine?
1. The blade of steel rule auto die bending machine cannot be cut. Check whether the three-carriage line is incorrect contact, and if it cannot be cut, the position of the two lines can be adjusted. Second, check whether the solenoid valve block is working properly.
2. The blade of steel rule auto die bending machine cannot be extended or retracted. Check whether the solenoid valve block is normal, and check whether the relay works normally.
3. The edge length of the blade is bent. Check whether the straightening wheel is loose.
4. There is a big error inside the length. Check whether the driving wheel is pressed tightly. Slipping can cause side-length data errors.
5. Rebar of steel rule auto die bending machine cannot be sent out from the tool holder. Check whether the automatic blade bending machine has selected a suitable tool holder according to the diameter of the blade.
6. When the automatic blade bending machine is cutting, the fracture is not neatly bent. Check whether the blade is severely worn, and change the direction of the blade in time, or update the blade.
7. The cut is weak. Check whether the hydraulic oil of the fully automatic blade bending machine is reduced. Check whether the valve size of the overflow valve has changed, the pressure can be adjusted through the valve or the system software.
1. When the upper sliding plate and each positioning axis of the steel rule auto die bending machine is not at the origin, run the return to origin program. After the equipment is started, it will run idle for 1-2 minutes, and move on the skateboard full stroke 2-3 times. If there is any abnormal sound or fault, stop immediately, remove the fault, and everything can work normally.
2. When working, one person should give the unified command, so that the operator of the steel rule auto die bending machine and the feeding and pressing personnel can cooperate closely, and ensure that the cooperating personnel is in a safe position before sending out the bending signal. According to the thickness and dimensions of the sheet to be bent, adjust the stroke of the slider and adjust the selection of the upper and lower molds and the bending pressure. When selecting the size of the lower die opening and checking the bending force of steel rule auto die bending machine, be sure to check the bending force table on the right side of the machine tool. The working bending force must not be greater than the nominal force.
1. The steel rule auto die bending machine does not need to add any auxiliary gas for cutting, and the consumption of laser cutting die is very low. The external power supply is 220V. There is no delay in opening preparation. The cutting cost is only 5 yuan/hour
2. It can cut 1mm-22mm wood board, plastic board, plexiglass, and acrylic board at a speed of 25-30m / h. Moreover, the steel rule auto die bending machine can cut gaps of 0.45mm, 0.71mm, 1.07mm, and 1.42mm, with uniform cutting width and up and down seams.
After understanding the working method and workflow of the steel rule auto die bending machine, do you also need to order a blade bending machine? For many years, Shenzhen Test Laser Equipment Co., Ltd. has been focusing on operating related products of automatic die blade bending machines. There are many kinds of products. I believe there will always be one that suits your needs.
