Views: 317 Author: Site Editor Publish Time: 2021-11-17 Origin: Site
With the development of science and technology, the performance of the die rule bending machine has been greatly improved, but there are still some small details that require our attention during use. Paying attention to these small details, we will be more comfortable with the use of the die rule bending machine.
What are the common troubleshooting methods of the die rule bending machine?
How to use die rule bending machine?
How does the die rule bending machine work?
1. The die rule bending machine cannot cut normally. First, check whether the three-vehicle lines are incorrect contact. If they cannot be cut off, adjust the position of the two-vehicle lines. Secondly, check whether the solenoid valve block works normally.
2. The side length error of the automatic bending machine is large. Check whether the drive wheel is compressed. Sliding will cause side length data error.
3. When cutting with a die rule bending machine, the fracture is not neat. Check whether the blade is seriously worn, change the direction of the blade in time, or update the blade.
4. The blade of the die rule bending machine cannot be retracted. Check whether the solenoid valve block is normal and whether the relay works normally.
5. The cut produced by the die rule bending machine is weak. Check whether the hydraulic oil of the full-automatic bending machine is reduced. Check whether the valve size of the overflow valve changes. The pressure can be adjusted by the valve or by the system software.
6. The reinforcement of the die rule bending machine cannot be sent out from the tool holder. Check whether the automatic blade bending machine selects the appropriate tool holder according to the blade diameter.
7. The edge length of the blade of the die rule bending machine is bent. Check whether the straightening wheel is loose.
1. First of all, we need to turn on the power supply of the die rule bending machine. By turning on the key switch on the control panel, and then pressing the oil pump to start, we can hear the sound of oil pump rotation. (at this time, the automatic bending machine has not started to operate)
2. The second step is stroke adjustment. The die rule bending machine must pay attention to adjust the stroke and try it before bending. When the upper die of the automatic bending machine is lowered to the bottom, there must be a gap of plate thickness. Otherwise, the mold and machine will be damaged. Stroke adjustment also includes electric quick adjustment and manual gastric adjustment.
3. The third step is to select the slot position of the die rule bending machine. Generally, 8 times the plate thickness and width shall be selected. If you bend a 4mm plate, you need to select a groove of about 32.
4. The fourth step is the rear stop adjustment of the die rule bending machine generally includes electric quick adjustment and manual fine adjustment, and the method is the same as that of plate shears.
5. The last step is to step on the footswitch and start bending. The die rule bending machine is different from the shearing machine. It can be released at any time. When you release your foot, the bending machine will stop and continue to descend when you press it.
Die rule bending machine is a machine that can cut thin plates. The structure mainly comprises a support, a workbench, and a sprayer. Place the workbench on the support. The worktable is composed of a base and a pressure plate. The fastening plates are connected, and the bass is composed of a shell, a coil, and a cover plate. The coil is arranged on the housing groove, and the upper end of the groove is covered with a cover plate. When in use, the Coyle can be powered on. After power is on, the pressing plate is generated according to gravity to realize the closing of the thin plate between the pressing plate and the base. With the electromagnetic gripper, the pressing plate can handle a variety of workpiece and sidewall operations, and the operation is very simple.
An die rule bending machine is a highly automated machine tool. Five basic slider mechanisms can be used for strip or wire, especially for streaming media, punching, and complex bending. Shenzen test laser equipment Co, Ltd is a die rule bending machine manufacturer established for more than 10 years. Please consult our company for details! Customer requirements are our pursuit.
